Sheet Bend

Form a loop in the thicker rope (blue) and hold it in one hand. Pass the thinner rope (red) through the loop and behind the (blue) tail and standing ends in that order. Finally, tuck the smaller rope under itself to finish the knot.

Uses: The Sheet Bend (ABOK # 1431, p 262) is recommended for joining two ropes of unequal size. The thicker rope must be used for the simple bight as shown. It works equally well if the ropes are of the same size.

Becket Hitch: The Becket Hitch is a very similar knot. However, it is a "Hitch": it does not join two ropes, it attaches a rope to a Becket (a rope handle or an eye). In the animation the Blue Rope would be Becket and the Red Rope would be tied to it with a Becket Hitch.

Tying it: The Sheet Bend would replace the Square (Reef) knot except for the awkward fact that it is not a binding knot – it has to be tied with both ends loose in your hands with no load on the ropes (The Square Knot - with all its faults - can be tied tight against a sail, or parcel, and usually stays tight while the second Half Hitch is tied).

Making a Cargo Net: Making a Cargo Net is tedious, time-consuming, and only to be undertaken out of necessity or by the enthusiast. The photograph shows the two knots usually used at each junction in the net. The Carrick Bend has been used in the upper row and the Sheet Bend has been used in the lower row.